The Sonifex HY-03S TBU from Eastern Electronics at only £629.99 inc. delivery & VAT

 

HY-03S

HY-03S

 

The HY-03 is a high quality analogue telephone hybrid, which is suitable for most general telephony applications and is often used in radio and TV stations, bingo halls and dealing floors. The analogue HY-03 telephone hybrid is the replacement for the HY-02, which for many years has set the standard as an excellent value, high quality telephone hybrid.

The HY-03 can be used for any application where a clean telephone signal is required and the line is not subject to delay. The HY-03 retains many of the features of the HY-02 and adds some additional ones. Some of the features of the HY-03 include :

  • Fully automatic – adapts to varying line conditions and has automatic signal limiting.
  • Local and remote line hold switching – calls can be remotely switched through a mixing console.
  • Momentary or permanent latching remotes can be enabled.
  • Balanced mic/line input – 10kohm balanced input selectable for 0dBu clean feed line, or microphone level with adjustable gain.
  • Balanced output – 0dBu low impedance balanced output, with output gain adjustment.
  • Mixed output – the output can be a mix of the caller and mic/line input signals for recording both sides of the telephone conversation.
  • Integrated ring detector – automatic call answering after a pre-determined number of rings.
  • Fitted with K-break disconnect detection as standard with an option for dial-tone disconnect (HY-03DTD option).
  • Line limiter, bandpass filter and output noise gate with preset threshold providing low distortion crystal clear audio.
  • 28dB typical line balance rejection.
  • Built-in power supply with switchable 115V, or 230V, mains input.
  • BABT approval compliant with European PTT specifications.
 
  Audio Specification
Input Impedance – Line Mode (Clean Feed) 10kohm balanced 0dB
Input Impedance – Microphone Mode 200ohm balanced
Clean Feed Limiting Input +4dBu
Microphone Level Range From 74dB to 40dB adjusted by preset pot
Bandwidth to Telephone Line 250Hz – 4kHz, -3dB ref 1kHz
Telephone Line Impedance Nominally 600ohm
Telephone Line Impedance Range 300ohm to 1500ohm
Output Impedance 50ohm balanced floating 0dBu
Output Level Range +8dB to –14dB adjusted by preset pot
Rejection Ratio 45dB on 1kHz tone, typically 28dB on complex waveforms, reference peak level of 0dB
Ring Detector Sensitivity 1 ring to 6 rings
Power 230V 50Hz, or 115V 60Hz.
6W for HY-03.
  Connections
Mic/Line Input XLR 3 pin female
Line Output XLR 3 pin male
Telephone Line RJ11 6/4 socket
Telephone Handset/Instrument RJ11 6/4 socket
Remotes 9-way female ‘D’ type (socket)
Power IEC mains (CEE22)
Each unit is supplied with 1 x RJ11 to RJ11 telephone line lead, 1 x RJ11 to BT plug telephone line lead, 1 x BT handset socket to RJ11 plug adapter, spare fuses (2) for 230V & 115V operation, IEC mains lead fitted with moulded mains plug, handbook and warranty card.

 

Click here to order!

See our contact page to order or get in touch

Back to Home page